ماكينة ثني الأنابيب TRANSFLUID DB 628 ST / SPS

tube diameter 6 - 28 mm
wall strength 2 mm
bending radius min. 2 x D
Control IPU 20
bending radius max. 5,0 x D mm
bending angle max. 190 °
arbor length 3000 mm
operating pressure 180 bar
hydraulic motor 4 kW
weight of the machine ca. 900 kg
dimensions of the machine ca. 3,8 x 1,1 x 1,3 m
Semi-automatic electro-hydr. mandrel tube bending machine with PLC control for
20 angles and display in the control panel for bending angle specification,
angle detection and angle measurement via absolute value encoder, autom. tool
plate reset, Turning device with digital display, hydr. quick chuck, aut.
Mandrel lubrication, adjustable length stops.
Operating modes: MANUAL and semi-automatic.
Control buttons: hydraulics on / off, operating mode selection, clamp to / on,
clamp forward / backward, mandrel forward / backward, bending forward /
backward /, locking forward / backward, mandrel lubrication, turning device
forward / backward, plate reset, length stop forward, emergency stop.
The machine comes from a prototype construction and was only used a little
until 2000. After that, the machines of this department were sold. However, the
purchaser did not use the pipe bending machine and therefore it has only stood
in the warehouse and has not worked since then.
Please notice that the price of a new machine today is over € 60.000,--.
Machine dealer with own stock of 1600 m².
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.